![]() ![]() Note: Connecting the auxiliary power input to the same PC being isolated will defeat the isolation property of HS02. The ADuM3165 supports low-speed (1.5 Mbps), full-speed (12 Mbps), and high-speed (480 Mbps) USB 2.0, while maintaining an isolation voltage rating of 3.75 kV rms. Linear power supplies and other earthed power supplies are not recommended. The CN0550 employs an ADuM3165 digital isolator to provide galvanic isolation of the USB data lines between the host and the peripheral device. It supports USB transfer modes Low (1. This product is capable of transmitting USB Hi-Speed (480 MBit/s) while providing full galvanic isolation of both the data and the power lines. The High-Speed isolator provides galvanic isolation between the USB host and device and protects the device from power shocks and avoid ground loops that can be very troublesome in audio. Previous isolators were limited to Full Speed (12 MBit/s) and Low Speed (1.5 MBit/s) transmission. Please note that it's recommended to use power supplies isolated from the earth ground like a modern phone charger. Overview Leading innovation: Intona has invented USB 2.0 Hi-Speed galvanic isolation. When the device connected to HS02 exceeds the current output capability, an external auxiliary power supply can be used. (Front ports, USB hub are less desirable). *We recommended connecting the HS02 directly to USB ports on the motherboard. For USB devices which are powered via the USB port This new product is capable of transmitting USB Hi-Speed. ![]() For USB devices which are not USB-poweredĢ. Previous isolators were limited to Full Speed (12 MBit/s) and Low Speed (1.5 MBit/s) transmission. For wired 2 ch AES/EBU, AEQ3id, SP/DIF, use our high CMRR Shielded transformers. Alternative solutions, beside TOS-LINK, industry standard AES-67 for Audio over IP, via Ethernet, up to 128 channels 24 bit, with précis time stamp. Latency is only 0.073us, which fully meets the needs of hifi enthusiasts and professionals.ġ. Re: DIY High Speed (480Mbps) USB Isolator for audio using ISOUSB211. The powerful transmission capability is compatible with high resolution audio such as PCM 32bit/768KHz and DSD512 native. HS02 supports automatic identification of USB2.0 transmission at low speed, full speed and high speed. The HS02 has two input interfaces (including a USB-B and a Type-C) and two output interfaces (including a USB-A and a Type-C), either of which can be selected by an input or output switch. However, it doesnt guarantee support for full high-speed components. The Hs02 has a fully isolated design, which does not introduce new interference when the auxiliary power supply is used while the audio signal is isolated from ground loop interference. Used to FULLY isolate USB signals and 5v supply to any FULL speed USB device including CAT interfaces, radios with USB connection, external soundcards, etc. USB isolators Full (12 Mbps) USB Speed 4 kV Isolation Protection 15 kV ESD Protection -40 to +80C Wide Operating Temperature High Retention USB Connectors. The USB type supports a full speed of 12 Mbps and a low speed of 1.5 Mbps. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |